Machine Operation; Pre-Operation; Burnishing With The Push Model - Nobles SpeedGleam Serie Manual Del Operador

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
WARNING: To reduce the risk of fire,
explosion or personal injury, do not use
flammable liquids or operate machine in or near
flammable vapors/liquids or combustible dusts,
as the electric motor will spark upon start up and
during operation which could cause a flash fire or
explosion. This machine is not equipped with an
explosion proof motor.
PRE–OPERATION
1. Sweep floor and remove debris.
2. Check condition of pad.
3. Check battery charge level (For accurate reading
pad must be spinning). Batteries will need
recharging if battery meter reads in the yellow or
red zone.
4. Check that the dust control bag is installed.
5. Make sure the floor is completely dry.

BURNISHING WITH THE PUSH MODEL

1. Turn key on, if equipped, then turn the main power
to the ON position (Figure 8).
FIG. 8
2. Pull the trigger switches to start the pad spinning.
The pad will automatically draw to floor (Figure 9).
Nobles SpeedGleam/Plus (01–02)
Home Find... Go To..
FIG. 9
3. Slowly push the machine forward to begin
burnishing.
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
4. Press the pad pressure switch to increase (+) or
decrease (–) the pad pressure. Adjust the pad
pressure so that the pad pressure meter reads
within the green zone (Figure 10).
ATTENTION: Do not operate the machine with the
pad pressure meter adjusted in the red zone, floor
damage and brush motor overload will result.
FIG. 10
NOTE: If machine vibrates, remove pad and realign.
ATTENTION: Keep machine moving at all times to
prevent floor damage.
5. To stop burnishing, release the triggers. The pad
will automatically raise to the transport position.
FOR SAFETY: When transporting machine, do not
lift machine if batteries are installed.
OPERATION
9