Bar Tack Stitch - Singer ET-1 Manual De Instrucciones

BAR TACK STITCH

A-22
D
1
2mm
3
4
5
2
6
1
1 Select pattern 22 of
"A" to get the bar tack stitch. Change the
presser foot to the buttonhole foot.
2
2 Pull the button holder to the rear. Set the
button guide plate on the buttonhole foot to
the desired length.
3
3 Position the fabric so that the needle is 2mm
(1/16") in front of where you want the
sewing to start, and then lower the presser
foot.
4
4 Pass the upper thread down through the
hole in the presser foot. Pull down the
buttonhole lever. The buttonhole lever is
positioned behind the bracket on the
buttonhole foot. Gently hold the end of the
upper thread in your left hand, and then
start sewing.
5
5 Bar tack stitches are sewn.
6
6 As an example, the illustration shows the
procedure for sewing bar tacks at pocket
corners.
42
from the Group Patterns