Replacing Brushroll - Uline SANITAIRE EON QUIET CLEAN Manual Del Usuario

REPLACING BRUSHROLL

CAUTION! Ensure vacuum is turned off and
unplugged before replacing the brushroll.
Routine maintenance of your vacuum will help avoid
unnecessary service calls. Check the brushroll often.
1. Lay vacuum on side so brushroll side plate is on top.
(See Figure 20)
Figure 20
2. Press brushroll release button. While holding button
down, lift off side plate. (See Figure 21)
Figure 21
PAGE 8 OF 27
MAINTENANCE CONTINUED
3. Rotate brushroll forward (clockwise) and lift out.
4. Slide clean or new brushroll back into housing and
5. While pressing brushroll release button, press the
Remove debris. (See Figure 22)
Figure 22
turn counterclockwise until it locks into place.
side plate back into place.
0421 IH-7147