Uline SANITAIRE EON QUIET CLEAN Manual Del Usuario página 6

CLEANING AIR PATH
1. To check nozzle head, remove cover from air path
cleanout. Turn cover counterclockwise and pull off.
2. Use finger to check for and clear debris.
(See Figure 13)
Figure 13
3. Reposition air path cover and turn clockwise to
secure.
CLEARING WAND AND HOSE
1. Use a rod or similar blunt implement to clear a
blockage in wand or hose. (See Figure 14)
2. Sometimes an obstruction can be cleared by
squeezing or flexing hose. Use extreme care if risk of
glass, nails or other sharp objects imbedded in hose.
(See Figure 14)
NOTE: Warranty does not cover any damage to
hose caused by cleaning.
Figure 14
PAGE 6 OF 27
OPERATION CONTINUED
BRUSHROLL CHECK LIGHT
1.
2. If red light turns on or brushroll stalls, vacuum will turn
3. Unplug electrical cord and turn power switch off to
4. Turn power switch on and wait one minute. After
5. Step on handle release pedal to lay vacuum flat;
6. Check and clear any obstructions to the brushroll.
7.
8. If there is no blockage, raise brushroll higher before
If red light stays off, brushroll is operating correctly.
off automatically.
reset.
turning switch on, expect a short delay before motor
starts.
turn over.
Use scissors to clip threads or strings. Remove
brushroll if needed. (See Figure 15)
Figure 15
using again.
0421 IH-7147