Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Open the vehicle trunk and carefully remove the plastic
trim panels on each side (Fig. 1A) and to the rear of the
trunk (Fig.1B).
3. Locate the vehicle harness
connectors. They will be similar
in appearance to those on the
T-Connector.
4. Beginning on the left
(driver's) side, carefully separate the vehicle
harness connectors, taking care not to damage the
locking tabs.
5. Position the T-Connector ends with the Yellow wires
between the separated ends and carefully press firmly
together until the locking tabs engage.
6. Locate an appropriate position on the vehicle frame to
attach the grounding screw. Clean away any dirt or debris
and drill a 3/32" hole.
Caution: Do not drill into any exposed surfaces or
through
the vehicle body.
7. Mount the White wire using the ground screw and eyelet
provided.
Fig. 1
Publicidad
