Install The Hood - Broan QP Serie Manual De Instrucciones

3¼" x 10"
HORIzONTAL
KNOCKOUT
PLATE
9 DuctED inStaLLation onLY:
Remove 3¼" x 10 vertical, 3¼" x 10" horizontal, or 7-inch
round knockout plate(s) as appropriate for your ducting
method.
7" ROUND
DUCT
PLATE
10 DuctED inStaLLation onLY:
Attach 3¼" x 10" Damper/Duct connector (if using
3¼" x 10" duct) or 7" round Duct Plate (if using 7-inch
round duct) over the knockout opening.
note:
To accomodate off-center ductwork, the 3¼" x 10"
damper/duct connector can be installed up to 1" on either
side of the hood center and the 7" round duct plate can
be installed up to ½" on either side of the hood center.
Trim the flange on the duct connector or duct plate if it
interferes with the electrical cable clamp.
models QP130Bl • QP130BlC • QP130ss • QP130ssC
QP130WW • QP130WWC • QP136Bl • QP136ss • QP136WW
7" ROUND
KNOCKOUT
PLATE (also
remove 3¼" x 10"
vertical plate)
3¼" x 10"
VERTICAL
KNOCKOUT
PLATE
3¼" x 10"
DAMPER /
DUCT
CONNECTOR

inStaLL tHE HooD

warning
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
ELECTRICAL
POWER
CABLE
KNOCKOUT
11 Remove Electrical wiring Box cover from inside
of hood and appropriate Electrical Power cable
Knockout from top or back of hood.
HOUSE
POWER CABLE
12 Run House Power cable between service panel
and hood location. Attach power cable to hood using
appropriate clamp.
13 Hang hood from (5) mounting screws driven part-way
into cabinet locations (shown in illustrations under
"PREPARE HOOD LOCATION"). Mounting screws are
included in parts bag. Slide hood back towards wall until
mounting screw heads are engaged in narrow end of
keyhole slots in top of hood. Tighten screws securely.
14 DuctED inStaLLation onLY:
Connect ductwork to hood and use duct tape to make
joints secure and air-tight. Make sure the damper / duct
connector enters the ductwork and that the damper
opens and closes freely.
Page 
ELECTRICAL
WIRING BOx
COVER