Install Backsplash; Install The Hood - Broan BEST K15 Manual Del Usuario

INSTALL BACKSPLASH

If optional backsplash is used, attach it to the
finished wall. Secure hood mounting brackets
to the backsplash and omit wall framing
described below.
INSTALL THE DUCTWORK
NOTE: To reduce the risk of fire, use only
metal ductwork.
1. Decide where the ductwork will run between
the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most efficiently.
3. Long duct runs, elbows, and transitions will
reduce the performance of the hood. Use as
few of them as possible.
4. Install a roof or wall cap. Connect 6" round
metal ductwork to cap and work back to-
wards hood location. Use duct tape to seal
the joints between ductwork sections.
INSTALL MOUNTING
BRACKETS
1. Construct wood wall framing that is flush
with interior surface of wall studs.
Make sure:
a) the framing is centered over installation
location.
b) the height of the framing will allow the
mounting brackets to be secured to the
framing within the dimensions shown.
2. After wall surface is finished, secure
mounting brackets to framing using
dimensions shown.

INSTALL THE HOOD

1. Hang the hood from the brackets through
the rectangular cut-outs on the back of the
hood. Cut-outs are larger than the brackets
to allow for horizontal adjustment.
The bottom of the hood should be 24" to 30"
above the cooking surface.
2. Height adjustment screws provide vertical
adjustment.
3. Depth adjustment screws provide
horizontal adjustment.
4. Secure the hood with additional mounting
screws. Use drywall anchors, provided, if
wall studs or framing are not available.
(OPTIONAL)
DECORATIVE
FLUE
HOOD
24" TO 30" ABOVE
COOKING SURFACE
X
= min 30 3/8" - max 36 7/16"
ADDITIONAL
MOUNTING
SCREWS
DEPTH ADJUSTMENT SCREWS
HEIGHT
ADJUSTMENT
SCREWS
ADDITIONAL MOUNTING SCREWS
- 3 -
ROOF CAP
6" ROUND
DUCT
ROUND
ELBOW
FRAMING BEHIND DRYWALL
5
5/16"
5
5/16"
above cooktop
RECTANGULAR
CUTOUTS
MOUNTING
BRACKETS
WALL
FRAMING
WALL
CAP
6"
2
3/16"
X