INSTALLATION—VENTED TO THE OUTSIDE
6
INSTALL DECORATIVE DUCT COVERS
on the support frame. This will make screw installation
easier.
pattern on one end.
For this vented installation to the outside, the hole
pattern should be located at the bottom.
and push to the ceiling.
top with 2 supplied duct cover screws.
14
Installation Instructions
tighten against the frame to allow the second duct
cover to slide up and pass over.
duct cover and push up past the stop screw location.
bottom duct cover and prevent it from sliding down
onto the top of the hood.
CAUTION
The stop screw must be installed.
to the duct cover.
31-10725 Rev. 6