INSTALLATION—RECIRCULATING
6
INSTALL DECORATIVE DUCT COVERS
on the support frame. This will make screw installation
easier.
pattern on one end.
For this recirculating installation, the hole pattern
should be located at the top.
and push to the ceiling.
top with 2 supplied duct cover screws.
31-10725 Rev. 6
Installation Instructions
tighten against the frame to allow the second duct
cover to slide up and pass over.
duct cover and push up past the stop screw location.
bottom duct cover and prevent it from sliding down
onto the top of the hood.
CAUTION
The stop screw must be installed.
to the duct cover.