Design Information; Models Available; Product Dimensions And Clearances - Monogram ZV850 Instrucciones De Instalación

CONTENTS
Safety Information ....................................................... 2

Design Information

........................................................... 3
...................................................... 3
Advance Planning
....................................................... 4
Installation Preparation
..................................................................
................................................................
Tools and Materials Required .......................................
Check Installation Hardware ........................................
Determine Installation Height ........................................ 8
Install Ceiling Support Structure ..............................
Installation Instructions

MODELS AVAILABLE

necessary parts for recirculating operation are supplied

PRODUCT DIMENSIONS AND CLEARANCES

The vent hood must be
installed 24" minimum
the cooking surface.
NOTE: Installation height
should be measured from
the cooking surface to the
lowest part of the hood.
31-10725 Rev. 6
Design Information
......................... 4
................................................
......................
.............................................. 12
.......................... 12
.......................... 12
................................................. 13
24" Minimum
30" Maximum
36" Minimum
.....................................................
..................................................
Installation Instructions
..............................................
................................................. 18
.....................................................
.................................................. 21
Reversible duct covers accommodate recirculating
operation.
The telescopic duct covers conceal the ductwork
running from the top of the hood to the ceiling.
The supplied duct cover is sized to reach ceiling heights
over 8 feet. See the table on page 8.
ZX8510SPSS Duct Cover Accessory
This accessory is available for installation with ceiling
The duct cover accessory must be on-site with the hood
at the time of installation.
35-3/8 (excluding utensil rods)
36-1/2 (including utensil rods)
............................... 13
....................... 14
...........................................
..................................
.......................................
....................................
..........................
.......................... 18
............................... 18
.......................
...........................................
..................................
....................................... 21
*Height
to Ceiling
8-1/4"
27-1/2"
3