Passive Extension Operation - ABB 6402U-500 Manual De Instrucciones

Operation
Passive Extension Operation via Pushbutton
The operation effected via the NO-contact pushbutton
causes the connected consumers
a. to be switched ON and OFF in Operating Mode 1
b. in Operating Modes 2 - 5,
- irrespective of the brightness measured (Output K1),
- to be switched on for approx. 80 seconds when FM
Sensors 6810-xxx-10x-500 are used
- to be switched on for the time set on the FM sensor
when FM Sensors 6800-xxx-10x(M)-500 are used (even
with time settings of less than 1 minute)
- to be switched over (ON > OFF > ON > ...) when the
Busch Watchdog
NOTE
- In the case of extension operation via NO-contact
pushbuttons, the maximum length of the
extension line must not exceed 100 m.
- Use only pushbuttons without contact-parallel illu-
mination.
82
Präsenz 6813-xxx-500 is used.
®
GB
82