General Usage; Using The Chronograph - Bell & Ross BR03-94 BR-CAL.301 Noticia Técnica

Ocultar thumbs Ver también para BR03-94 BR-CAL.301:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 9
BR 03-94
BR-CAL.301
Movement
: mechanical with automatic winding. Calibre BR-CAL.301. Power
reserve approximately 40 hours.
: hours, minutes and sub seconds.
Functions
Chronograph: 30-minute and 60-second counters. Date with quickset. Time-setting
with hacking function.
: 42 mm in diameter.
Case

GENERAL USAGE

Starting the watch.
When the watch has stopped (crown in position 0) : wind the
movement by rotating the crown clockwise. After approximately 40 rotations, the
watch is fully wound (the winding mechanism does not have a stop to prevent over-
4
winding). The power reserve is approximately 40 hours when fully wound. When
the watch is worn, the automatic mechanism will wind the movement.
. Pull the crown out to position 2. The seconds hand will stop, enabling
the time
you to set the time to the nearest second. Set the time by rotating the crown in
. Quickset* (crown in position 1)  : pull the
the required direction.
Setting the date
crown out to position 1 and set the date by rotating the crown anticlockwise. S low
setting (crown in position 2): to ensure the date changes at midnight rather than
noon, it is recommended you set the date by adjusting the hands of the watch. Pull
the crown out to position 2 and turn the hands until the date changes. Then set
the precise time.

USING THE CHRONOGRAPH

The chronograph function can measure time in minutes and seconds.
Measuring the time.
1
st
press of Pusher P
: sets off the time measurement.
1
2
press of Pusher P
: stops the time measurement.
nd
1
3
rd
press of Pusher P
: stops and resets the chronograph.
2
Measuring the time with an interruption
1
press of Pusher P
: sets off the time measurement.
st
1
2
nd
press of Pusher P
: stops the time measurement.
1
3
press of Pusher P
: restarts the time measurement.
rd
1
This allows one or several time intervals to be subtracted from the total time
measured.
4
th
press of Pusher P
: stops the time measurement.
1
Setting
5
th
press of Pusher P
: stops and resets the chronograph.
2
A. Minute hand
B. Chronograph 60-second hand
C. Hour hand
D. Chronograph 30-minute counter
E. Seconds hand
F. Case attachment screw
(NEVER UNSCREW)
G. Strap attachment
H. Date
I. Crown
B
.
C
D
E
F
G
P
. Pusher 1. Start/Stop
1
P
. Pusher 2. Reset
2
0. Wind the movement manually (rotate clockwise)
1. Set the date (rotate anticlockwise)
2. Set the time (rotate in either direction)
A
(x4)
P
1
0
1
2
I
P
2
H

Publicidad

Tabla de contenido
loading

Tabla de contenido