Nice Robus 600 Manual Del Usuario página 17

courtesy light
electric lock 1
suction cup 1
radio channel no.1
radio channel no.2
radio channel no.3
radio channel no.4
This function type is ON/OFF. Important – For safety reasons,
as the light is not controlled by a timer, use of an adequate light,
able to withstand the heat of the light emitted, is recommended.
With this function programmed, when an Opening manoeuvre
is performed the electric lock is activated for a time as set in
the function "electric lock time – output configuration".
Output active 24 Vdc / max 4 W
With this function programmed, the suction cup is activated
when the application is in the maximum Closing position. Note
– The suction cup is disabled in all other situations.
When the suction cup is disabled, before an Opening manoeu-
vre is started, the time interval as programmed in the function
"suction cup time – output configuration" is activated, which
delays the start of the manoeuvre.
If this radio channel is set for the configuration of output 1
(flash), this channel is activated when a command is set with
the transmitter. It is useful if installing external devices (for
example, an auxiliary light) in the same system to be controlled
with a single transmitter.
WARNING – If this channel is not free on the control unit
receiver, as previously memorised with a command, the con-
trol unit activates exclusively the programmed output when the
channel is activated with the transmitter, ignoring the com-
mand to the motor.
Output active 24Vdc / max 4 W
If this radio channel is set for the configuration of output 1
(flash), this channel is activated when a command is set with
the transmitter. It is useful if installing external devices (for
example, an auxiliary light) in the same system to be controlled
with a single transmitter.
WARNING – If this channel is not free on the control unit
receiver, as previously memorised with a command, the con-
trol unit activates exclusively the programmed output when the
channel is activated with the transmitter, ignoring the com-
mand to the motor.
Output active 24Vdc / max 4 W
If this radio channel is set for the configuration of output 1
(flash), this channel is activated when a command is set with
the transmitter. It is useful if installing external devices (for
example, an auxiliary light) in the same system to be controlled
with a single transmitter.
WARNING – If this channel is not free on the control unit
receiver, as previously memorised with a command, the con-
trol unit activates exclusively the programmed output when the
channel is activated with the transmitter, ignoring the com-
mand to the motor.
Output active 24Vdc / max 4 W
If this radio channel is set for the configuration of output 1
(flash), this channel is activated when a command is set with
the transmitter. It is useful if installing external devices (for
example, an auxiliary light) in the same system to be controlled
with a single transmitter.
WARNING – If this channel is not free on the control unit receiv-
er, as previously memorised with a command, the control unit
activates exclusively the programmed output when the channel
is activated with the transmitter, ignoring the command to the
motor.
Output active 24Vdc / max 4 W
Robus 600-1000 – 17