Abicor Binzel xFUME FLEX Manual De Instrucciones página 41

®
xFUME FLEX
Electric shock due to defective cables
Damaged or improperly installed cables can lead to fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Damaged, deformed or worn parts should only be replaced by a qualified electrician.
Risk of crushing
Limbs can be crushed if device components are improperly installed or uninstalled.
► Keep your hands out of the danger zone.
► Check and wear your personal protective equipment.
Risk of injury due to unexpected start
If power is supplied during maintenance, cleaning or disassembly, rotating parts can start running
unexpectedly and lead to injuries from cuts.
► Switch off the device.
► Disconnect all electrical connections.
9.1 Maintenance and cleaning intervals
The specified intervals are standard values and refer to single-shift operation. We recommend recording the
inspections. The date of the inspection, the detected defects and the name of the inspector must be observed.
Daily
Weekly
Monthly
9.2 Replacing the pre-filter
The filter pad (B) is the most important element. When replaced regularly, the service life of the pre-filter
is prolonged. Cleaning the filter pad with compressed air or a hammer is not permitted. The filter pad must
be replaced.
WARNING
WARNING
CAUTION
► Check the pre-filter and primary filter and replace as needed.
 9.2 Replacing the pre-filter on page EN-18
 9.3 Replacing the primary filter on page EN-19
► Check the extraction arm and replace as needed.
 9.5 Replacing the extraction arm on page EN-20
► Clean outer surfaces.
 9.4 Cleaning outer surfaces on page EN-20
9 Maintenance and cleaning
Turn the <ON/OFF> switch (D) to <O>.
1
 Fig. 2 Assembly and use on page EN-11
Pull out the mains plug.
2
Unlock and open the service door using a square
3
wrench.
Remove the pre-filter.
4
EN - 17