Grundfos CIM 260 Instrucciones De Instalación Y Funcionamiento página 11

Cellular modules
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
CIM 260 or 280 fitted in the CIU unit
Fault (LED status)
1.
Both LEDs (LED1 and LED2)
remain off when the power
supply is connected.
2.
The LED for internal
communication (LED2) is
flashing red.
3.
The LED for internal
communication (LED2) is
permanently red.
4.
LED1 is flashing yellow.
5.
LED1 is pulsating yellow with
single pulse, but CIM 260
cannot send or receive SMS
messages.
Possible cause
a)
The CIU unit is defective.
b)
The CIM module is defective.
c)
The CIM interface or the CIM
connector in the product is
defective.
a)
No internal communication
between CIM 260 and the
Grundfos product.
a)
CIM 260 does not support the
Grundfos product.
b)
CIM 280 is not configured.
The product driver is not
downloaded from the cloud
yet.. When CIM 280 is
switched on, the LED2 may
turn green for 1 minute before
it turns permanently red.
a)
The SIM card has not been
inserted.
b)
The SIM card has not been
inserted correctly.
c)
The PIN code of the SIM card
has not been removed or set
to 4321.
d)
No connection to the cellular
network.
a)
CIM 260 has not been
initialised.
Remedy
Replace the CIU unit.
Replace the CIM module.
Contact Grundfos.
• Check the cable connection
between the Grundfos product
and CIM 260.
• Check that the individual
conductors have been fitted
correctly.
• Check the power supply to the
Grundfos product.
Contact the nearest Grundfos
company.
Run the CIM setup process in the
cloud. Contact the nearest
Grundfos company.
Insert the SIM card. See section
2.6 Inserting the SIM
card.
Insert the SIM card. See section
2.6 Inserting the SIM
card.
Remove the PIN code, or set it to
4321 with a mobile phone. See
section
2.6 Inserting the SIM
• Check the connection to the
antenna.
• Check the cellular coverage of
the area with for instance a
mobile phone. Experiment with
the position of the external
antenna.
• In some cases, adding an
additional antenna to the
second SMA connector may
improve the signal. See fig. 3.
Initialise CIM 260 with the
command INIT. See section
2.6 Inserting the SIM card
manual "CIM 260 SMS
commands".
card.
in the
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cim 28

Tabla de contenido