Kärcher KSM 690 BAT Manual De Instrucciones página 11

1. Unpacking and assembly
Owing to packaging design considerations, the unit is shipped
only partially assembled. To assemble the unit, perform the
following steps in the sequence indicated:
A Assembling outrigger broom. Place drive disc and broom on
broom drive shaft and secure with flat washer and hex nut.
Caution: Drive pins in the broom base must engage in
drive disc.
Installing and Changing the Battery
– Fill battery with acid (see safety instructions and battery
manufacturer's information).
– Screw out screws from the protective cover and remove it.
– Unscrew battery bracket and insert battery, then secure
with bracket.
Note: Ventilator wheel must not touch any components
(i.e., cables), and cables must not project from unit.
B On the factory-packed unit, the push hand-
le is folded down. Mount securely, using
supplied nuts and bolts.
Caution: After mounting the push handle,
make sure that the unit main switch is in
the OFF position (white marking is visible).
C Connect battery cables to battery posts.
Note: red
black =
– Charge the battery (see section, "Important battery
information").
2. Operation
A Switch the unit ON by pressing the
unit main switch.
Press once – motor ON
Press twice – motor OFF
Note: The switch serves also as overload
protection. If it switches off, this is due to raised power
consumption. Wait at least 3 minutes and rectify the cause,
e.g. tangled cords, before switching on again.
= positive post (+)
negative post (–)
ENGLISH
11