Changing The Battery; Changing The Clipperhead - Heiniger Opal Traducción Del Manual Original

6.2.2 Changing the battery

When the battery is unloaded, the clipper is turned off by a protective circuit.
1
Fig. 20
1
Fig. 21

6.2.3 Changing the clipperhead

Fig. 22
Fig. 23
6. Fit the favoured clipperhead to the blade hinge and fold it on to the swit-
ched-on clipper by light pressure. (fig. 17, 18, 19).
NOTE!
Only work with sharp blades, replace blunt or defective blades without teeth.
The correct resharpening of blades is only to do by special machines or by a
specialist. In that case, contact your service centre.
Translation of the original instructions / Small animal clipper
1. Move the switch to position "0" (fig.4).
2. Push the battery interlock (2) on both
2
3. Insert charged battery (1) into the
2
1. Move the switch to position "0" (fig.4).
2. Push the interlock clipperhead.
3. Fold the clipperhead ahead when
4. Take off the clipperhead.
5. Clean the opened hinge by the help
sides inward and pull the battery (1)
out of the clipper.
shearer (2), until the battery lock is
locked in on both sides.
the interlock clipperhead is pressed.
of the provided brush.
15