Sanus VMF620 Manual De Instrucciones página 13

4
POSITION TEMPLATE
11
To calculate your precise wall plate location, check out
TIP:
our HeightFinder at sanus.com [www.sanus.com/1172].
Position wall plate template
11
holes over your stud center lines. Level and mark the hole locations.
Visit
HeightFinder™
sanus.com
/1172
at your desired height, with the slotted
5
DRILL
4X
11
Be sure you drill into the CENTER of the stud.
CAUTION:
Drill the four pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT: Pilot holes must be drilled to a depth of
Remove wall plate template and discard.
11
3 ½ in. (8.9 cm)
7/32 in.
(5.5 mm)
3 ½
in. (8.9 cm).
13