Technical Parameters; Other Information - Elko EP CRM-100 Manual De Instrucciones

Technical parameters

Number of functions:
Supply terminals:
Voltage range:
Consumption (apparent / loss):
Max. dissipated power
(Un + terminals):
Supply voltage tolerance:
Time ranges:
Time setting:
Repeat accuracy:
Variation in timing due to
voltage change:
Variation in timing due to
temperature change:
Output
Number of contacts:
Current rating:
Breaking capacity:
Inrush current:
Switching voltage:
Output indication:
Mechanical life:
Electrical life (AC1):
Controlling
Control. terminals:

Other information

Operating temperature:
Storage temperature:
Isolation (Between Input and
Output):
Operating position:
Mounting:
Protection degree:
Overvoltage cathegory:
Pollution degree:
Max. cable size (mm 2 ):
Dimensions:
Weight:
CRM-100
17
A1 - A2
AC/DC 24-240 V (50-60 Hz)
AC max. 1-4 VA / DC max. 1-3 W
4 W
-15 %; +10 %
0.1 s - 999 hrs.
Buttons SET / ADJ
± 0.5 % - of selected range
± 2%
± 5%
1x C/O / SPDT (AgNi)
8 A/ AC1
2000 VA / AC1, 192 W / DC
10 A / <3s
250 V AC/ 24 V DC
multifunction red LED
2 x 10 7
5
1 x 10
A1-B1
14 .. 131 °F (-10 .. +55 °C )
-22 .. 158 °F (-30 .. +70 °C )
2.5 kV
any
DIN rail EN 60715
IP30 from front panel / IP20 terminals
III.
2
solid wire max. 1x 2.5 or 2x 1.5 /
with sleeve max. 1x 2.5 (AWG 12)
85 x 18.2 x 76 mm (3.3˝ x 0.7˝ x 2.99˝)
78 g (2.8 oz.)
Warning
The device is constructed for 1-phase main installation of 230V AC or AC/DC 24-240 V and
must be installed in accordance with regulations and standards applicable in the coun-
try of use. Installation, connection, setting and servicing should be installed by quali-
fi ed electrician staff only, who has learnt these instruction and functions of the device.
This device contains protection against overvoltage peaks and disturbancies in supply.
For correct function of the protection of this device there must be suitable protections
of higher degree (A,B,C) installed in front of them. According to standards elimination
of disturbancies must be ensured. Before installation the main switch must be in posi-
tion "OFF" and the device should be de-energized. Don´t install the device to sources of
excessive electro-magnetic interference. By correct installation ensure ideal air circula-
tion so in case of permanent operation and higher ambient temperature the maximal
operating temperature of the device is not exceeded. For installation and setting use
screw-driver cca 2 mm. The device is fully-electronic - installation should be carried out
according to this fact. Non-problematic function depends also on the way of transporta-
tion, storing and handling. In case of any signs of destruction, deformation, non-function
or missing part, don´t install and claim at your seller it is possible to dismount the device
after its lifetime, recycle, or store in protective dump.
3 / 3