Dremel 7350 Instrucciones De Funcionamiento página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1605A000DGAB 02-21 7350_7300-PGT 6/2/21 9:21 AM Page 13
Charge tool in temperatures above +32 degrees F (0 degrees
C) and below +113 degrees F (+45 degrees C). Store tool in
locations where temperatures will not exceed +122 degrees
F (+50 degrees C). This is important to prevent serious dam-
age to the battery cells.
Do not recharge tool in damp or wet environment. Do not
expose power adapter to rain or snow. Water entering power
adapter may result in electric shock or fire.
Battery leakage may occur under extreme usage or tempera-
ture conditions. Avoid contact with skin and eyes. The bat-
tery liquid is caustic and could cause chemical burns to tis-
sues. If liquid comes in contact with skin, wash quickly with
soap and water. If the liquid contacts your eyes, flush them
with water for a minimum of 10 minutes and seek medical
attention.
Place tool on flat nonflammable surfaces and away from
flammable materials when recharging. Carpeting and other
heat insulating surfaces block proper air circulation, which may
cause overheating of the power adapter and tool. If smoke or
melting of the power adapter or tool is observed, unplug the
charger immediately and do not use the tool or charger.
Contact customer service immediately.
Make sure that USB cable is located so that it will not be
stepped on, tripped over, or otherwise subjected to damage
or stress. Damaged plug and cable may result in electric shock
or fire.
Disconnect the tool from the power adapter by pulling the
plug rather than the cable. Do not operate power adapter
with damaged USB cable or plug; have them replaced imme-
diately. Damaged plug or cable may result in electric shock or
fire.
Do not disassemble power adapter or operate the power
adapter if it has received a sharp blow, been dropped or oth-
erwise damaged in anyway. Incorrect reassembly or damage
may result in electric shock or fire.
Before each use, check the power supply, USB cable and
plug. If damage is detected, do not use the power adapter.
Never open the power adapter yourself, take it to a Dremel
Factory Service Center, or qualified serviceman only using
original spare parts. Incorrect reassembly may result in elec-
tric shock or fire.
Do not use attachments not recommended or sold by Dremel.
Using attachments not recommended may result in electric
shock or fire.
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

7350-pet

Tabla de contenido