Dremel 7350 Instrucciones De Funcionamiento página 30

1605A000DGAB 02-21 7350_7300-PGT 6/2/21 9:21 AM Page 30
The Nail Grooming Process
Support the toe and nail in one hand while using the rotary tool
in the other hand. This is more comfortable for your pet as it
lessens vibration on the paw. Pushing gently on the bottom of the
paw's pad extends the nail slightly for easier grooming.
It is important to let the speed of the rotary tool do the work;
never apply pressure to the toenail with the spinning sanding
band. Pressure may cause the nail to grow too hot, resulting in
discomfort for your pet. The rotary tool's spinning sanding band
should not be kept against the nail longer than three seconds at
a time. Instead of focusing on completing one nail at a time, it is
recommended to briefly trim each nail on one paw, and then the
other, in several passes. This allows time for the nails to cool. You
may repeat this process as needed. Trim nails so that they almost
touch the ground when your pet is walking.
Pet Safety Tips
Some pets may become nervous in the presence of the tool so it
is best to secure your pet. The operator will need both hands to
groom the nails so it may be helpful to have another person assist
in restraining your pet.
If hair is accidentally caught in the rotary tool, immediately turn
off the tool and untangle the hair from the tool. For pets with par-
ticularly long hair, use an old sock to cover the toe, foot, and leg
of the pet and isolate the nail. Push the nail out through a small
opening at the tip of the sock to groom the nail. Keep styptic
powder on hand in case of bleeding. Styptic powder is available
at most pet supply stores. Follow the directions on the packag-
ing for proper use instructions.
30
Use only "Golf Grip" or "Pencil Grip"
method of holding the tool.