1605A000DGAB 02-21 7350_7300-PGT 6/2/21 9:21 AM Page 34
Structured Tungsten
Carbide Carving Bits
Fast cutting, needle-sharp
teeth for greater material
removal with minimum load-
ing. Use on fiberglass, wood,
plastic, epoxy and rubber.
1/8" shank.
Silicon Carbide Grinding
Stones (blue/green)
Tougher than aluminum oxide
points, these are made es -
pecially for use on hard mate-
rials such as glass and ce -
ramics. Typical uses might be
the removal of stilt marks and
excess glaze on ceramics and
engraving
shank.
Diamond Wheel Points
Excellent for fine detail work
on wood, jade, ceramic, glass
and other hard material. Bits
are covered with diamond
particles. 1/8" shanks. (Not
recommended for drilling)
34
on
glass.
1/8"
Wire Brushes
Three different shapes of
wire brushes are available.
For best results wire brush-
es should be used at speeds
not
greater
than
RPM. Refer to Operating
Speeds section for proper
tool speed setting. The three
shapes come in three differ-
ent materials: stainless steel,
brass and carbon wire. The
stainless steel perform well
on pewter, aluminum, stain-
less steel, and other metals,
without leaving "after-rust".
Brass brushes are non spark-
ing, and softer than steel;
making them good for use on
soft metal like gold, cooper
and brass. The carbon wire
brushes are good for general
purpose cleaning.
Polishing Accessories
These include an impregnat-
ed polishing point and an
impregnated polishing wheel
for bringing metal sur faces to
smooth finish; a felt polishing
tip and felt polish ing wheel,
and cloth polishing wheel, all
15,000