Dremel 7350 Instrucciones De Funcionamiento página 22

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1605A000DGAB 02-21 7350_7300-PGT 6/2/21 9:21 AM Page 22
Collets
Fig. 3
1
Collet nut
2a 1/8" collet 480 - no ID rings
2b 3/32" Collet 481 - three ID rings
2c 1/16" Collet 482 - two ID rings
2d 1/32" Collet 483 - one ID ring
2e ID ring
Four different size collets, to accommodate different shank sizes,
are avail able for your Rotary Tool. Collet sizes can be identified
by the rings on the back end of collet. 1/8" Collet has no rings and
is included in most tool kits.
To install a different collet, remove the collet nut and remove the
old collet. Insert the unslotted end of the collet in the hole in the
end of the tool shaft. Replace collet nut on the shaft.
Never force a larger diameter shank into a collet.
Note: Most rotary tool kits do not include all four collets sizes.
22
1
2a
2b
Always use the collet which matches the
shank size of the accessory you plan to use.
2c
2d
2e

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

7350-pet

Tabla de contenido