Dremel 7350 Instrucciones De Funcionamiento página 21

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1605A000DGAB 02-21 7350_7300-PGT 6/2/21 9:21 AM Page 21
lets or servicing your cordless rotary tool.
Collet Nut
To loosen the collet nut, first press shaft lock button and rotate
the shaft by hand until the lock engages the shaft preventing fur-
ther rotation. Your Dremel 7350 is equipped with a shaft lock
mechanism. This mechanism engages the output shaft in 4 sepa-
rate locations on the shaft for easier operation.
With the shaft lock 4 engaged, use the collet wrench 10 to loosen
the collet nut 1. The collet nut must be loosely threaded on when
inserting an accessory.
Change accessories by inserting the new one into the collet as far
as possible to minimize runout and unbalance. With the shaft lock
4 engaged, tighten the collet nut 1 securely with collet wrench 10
(Fig. 2). Avoid excessive tightening of the collet nut when there
is no bit inserted.
Fig. 2
Assembly
Always be sure the tool is turned "OFF"
before changing accessories, changing col-
Do not engage lock while the Rotary Tool is
running.
4
10
21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

7350-pet

Tabla de contenido