Dremel 7350 Instrucciones De Funcionamiento página 36

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1605A000DGAB 02-21 7350_7300-PGT 6/2/21 9:21 AM Page 36
Mandrel No. 401 is used with the felt polishing tip and wheels. Thread the tip on
to the screw carefully. The felt tip must thread down straight on the screw
Mandrel, and be turned all the way to the collar.
Mandrel No. 402 has a small screw at its tip, and is used with emery cutting
wheels and sanding discs. Higher speeds, usually maximum, are best for most
work, including cutting steel.
To replace a band on the Drum Sander, loosen the screw without removing it to
contract the drum then slide the old band off. Slide the new sanding band on and
then expand the drum by tightening the screw once again.
the drum is sufficiently expanded to secure the band during use. If sanding
band is loose on the drum during operation it may "fly" off and strike you or
bystanders.
36
Dremel Accessories
Before each use, check to make certain that all com-
ponents are assembled to accessory shank and that

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

7350-pet

Tabla de contenido