Publicidad
Idiomas disponibles
Idiomas disponibles
®
Worksurface-to-Tower
Connector
NOTE: Can be mounted on
either side of storage unit.
NOTE: Make sure storage
unit is level. Make sure the
panel system is level, if the
worksurface and/or tower is
connected to a panel system.
NOTE: 24" deep
worksurface will use the 24"
bracket & the 30" deep
worksurface will use the 30"
bracket.
1.
Hold the worksurface up
next to the storage unit. Place
level on worksurface as
shown. Raise/Lower
worksurface until level (1a).
Using the bottom of the
worksurface, mark a line (1b).
2.
Back edge of bracket
should be approx. 3/4" from
back of storage unit. Place
level on top of bracket and
align top of bracket with
marked line on previous step.
Mark holes on storage unit
(2a). Remove bracket and
drill five (5) 1/8" diameter
holes in storage unit (2b).
1a
1b
2b
1/8" DIA. HOLE
3/4"
2a
Page 12 of 39
76456 Rev C
Publicidad
