Steelcase High-Density Storage Instrucciones De Montaje página 10

®
Storage-to-Panel
Connector
(continued)
10a
10.
Slide the storage unit up
against the bracket assembly,
making sure to line up the studs
on the bracket assembly with the
drilled holes on the back of the
storage unit (10a).
10b
Install a 1/4-20 flanged hex nut
and washer onto each stud from
inside the storage unit (10b).
Tighten to a maximum of 8 ft-lbs.
Do not use an impact wrench for
this installation.
BRACKET
ASSEMBLY
1/4-20 FLANGED HEX NUT
WASHER
BRACKET ASSEMBLY
Page 10 of 39
76456 Rev C