Steelcase High-Density Storage Instrucciones De Montaje página 3

®
Leveling and Adjusting
Caster Height
1.
Move unit into place.
2.
Open door about 5".
3.
Level tower front-to-back & side-to-side by adjusting
the glides on the bottom of the unit. Adjust casters up &
down by using a #3 phillips drive screwdriver and adjusting
the interal holes within the case (3a). Adjust the outer head
left-to-right & top-to-bottom with the exteral holes within the
case using a #3 phillips drive screwdriver (3b). These
screws provide vertical and angular adjustment of the outer
head to give proper alignment of the outer head to the
case. Turning the screws counter-clockwise lifts the
outer head and tilts the top of the outer head back
towards the case.
Note:
Turn screwdriver
counter-clockwise
to lower caster.
2
3a
3b
between caster and floor.
5"
Note: Adjust caster to
allow 1/32" (1mm)
CASTER
Page 3 of 39
76456 Rev C