Publicidad
Idiomas disponibles
Idiomas disponibles
®
Storage-to-Panel
Connector
1.
Level the panel system.
2.
Level the storage unit in
the location where it will be
installed by performing steps 2
and 3 on page 2 to remove
interior after unit is leveled.
3.
Install the bracket assembly
by tilting the top hook into the
slot (3a) then rotating the bottom
down (3b). Make sure the safety
clip is fully engaged into the
panel slot. See step 9 on page 8
for clarity.
NOTE:
For Answer panels,
bottom hook must be installed in
the first slot from the bottom.
4.
Measure from the floor to the
center of the bottom stud on the
bracket assembly.
WL = Wood Left
WR = Wood Right
A = Answer
FIRST SLOT
FROM BOTTOM
3a
3b
1
MEASURED
DIMENSION
F L
4
R
O O
Page 7 of 39
76456 Rev C
Publicidad
