Publicidad
Idiomas disponibles
Idiomas disponibles
®
Storage-to-Panel
Connector
(continued)
11.
Pull bottom chassis out
fully (11a). Place unit down on
top of the chassis as far back as
possible (11b). If light is installed,
connect light cord between the
inner and outer case.
Close door to fully closed
position (you may need to slam
closed to fully position interior).
Slowly open as to not allow the
interior to slide on lower chassis
member. Reinstall two (2)
screws removed in step 1 on
page 4 of removing the interior.
11a
BOTTOM
CHASIS
11b
Page 11 of 39
76456 Rev C
Publicidad
