Publicidad
Idiomas disponibles
Idiomas disponibles
FITTING THE BATTERIES.-
This monitor uses two 1.5 volt Alkaline
Batteries. To fit the batteries, remove
the rear cover on the monitor, Fig.1,
and carefully insert the two "AAA" type
batteries into the battery compartment
making sure that the battery's polarity
is correct (matching the battery's «+»
terminal with the «+» sign inside the
battery compartment, and the «-»
terminal with the «-» sign). Close the
cover.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important:
components in special containers,
Fig.2.
1.-ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous
distance - exercise time, pulse, level,
and watts-calories burnt.
The screen will switch itself on
automatically as soon as you start
exercising or pressing a key.
After the exercise, the monitor will
display for 60 seconds:
TIME
- Exercise time
DIST
Distance travelled
AVG RPM - Average cadence
Deposit
electronic
read-outs
of
English
AVG PULSE Average heart rate
KCAL
AVG WATT Average watts
The monitor will switch itself off
automatically if the unit stands idle for
more than 60 seconds, resetting the
values of the session.
2.- TELEMETRIC PULSE RATE
To measure your pulse rate during
exercise you will need to wear the
chest band (OPTIONAL). Fig.3.
See telemetric pulse rate instruction
book).
TROUBLESHOOTING GUIDE.-
Problem: Display segments of a
function read-out are not visible or
error
function appear.
Solution:
a.- Make sure that the connection
cables are connected. A and B Fig.4.
b.- Check the battery charge If it is run
down change the battery for one of the
same type.
c.- If the above steps do not help then
replace the electronic monitor.
rpm,
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
We recommend that your use original
spare parts to replace any worn
components. The use of other spare
parts may cause injuries or affect the
performance of the machine.
5
- Kilocalories burned
messages
for
a
particular
Publicidad
