Led For Indication Of Ir Communication; R100 Remote Control - Grundfos IO Instrucciones De Instalación Y Funcionamiento

5.7 LED for indication of IR communication

When communication has been established using
the Grundfos R100 remote control, LED2 (pos. 12) is
flashing green.
The IO module is designed to communicate with the
R100.
The R100 is used for the following purposes:
• to read system and pump status
• to read alarms and warnings
• to set or change application and pump
parameters.
See section 6. R100 remote control.
IR communication
Fig. 13
18

6. R100 remote control

The CIU unit is designed for wireless IR
communication with the Grundfos R100 remote
control.
During communication, the R100 must be pointed at
the CIU unit.
The R100 offers additional setting options and status
displays for the pump.
The R100 displays are divided into eight parallel
menus (fig. 14):
0. GENERAL
See operating instructions for the R100.
1. OPERATION
2. STATUS (SYSTEM)
3. STATUS (PUMP 1)
4. STATUS (PUMP 2)
16
5. STATUS (PUMP 3)
6. STATUS (PUMP 4)
7. SYSTEM INSTALLATION
The number stated above each individual display in
fig. 14 refers to the section in which the display is
described.