Samsung SNC-C7478 Manual Del Usuario página 30

How to use OSD Menu
SET HOME POSITION
MOVE TO TARGET POSITION
[NEAR:SELECT / FAR:CANCEL]
• Set Home Position
HOME position means the origin of PAN angle
calculation. The value of PAN angle displayed on the
screen is based on this HOME position.
By using Joystick, move the camera to the desired
position and press ENTER (NEAR/SELECT).
It is noted that Home is not effective to Tilt angle.
 If you change the location of Home position, all
horizontal locations of functions such as preset,
pattern, scan, auto pan, and privacy zone mask will
be shifted based on changed Home position.
 If there are no setup for those functions like Preset,
Pattern, Auto Pan and Scan, Camera will automatically
move to Home position after rebooting.
If Power Up Action is set to be ON, camera will
continue the function which is executed lastly after
rebooting.
0 – 36x IP Smart Dome Camera
0/0/x1/N
* Set Home Position?
When you replace the camera block or the
orientation of camera is changed due to
maintenance operations, it is very difficult to
maintain same pan orientation. Therefore, all
function data depending on pan orientation such
as preset, pattern, scan, auto pan, and privacy
zone mask are not useful any more accordingly.
However, even in this case, you can reuse the data
if you redefine Set Home Position on the previous
Home position. It is recommendable to memorize
the target scene of current Home position.
SET NORTH DIRECTION
MOVE TO TARGET POSITION
[NEAR:SELECT / FAR:CANCEL]
• Set North Direction
You can set up North direction.
By using Joystick, move the camera to the desired
NORTH position and press ENTER (NEAR/SELECT).
The direction will be displayed in the screen
[PAN AXIS / TILT AXIS / ZOOM / DD]
DD is direction and will be displayed from:
[N/NE/E/SE/S/SW/W/NW]
• Language
You can select a preferred Language of OSD display
from 7 choices.
[ENGLISH/ ESPAÑOL/ FRANÇAIS/ DEUTSCH/
ITALIANO/ РУССКИЙ/ PORTUGUÊS]
After selecting a language, press the Near or eNTer
key.
0/0/x1/N