Auto Pan Setup; Pattern Setup - Samsung SNC-C7478 Manual Del Usuario

How to use OSD Menu
If you want to use blank, choose Space character
(" "). If you want to delete a character before, use
back space character ("").
 If you complete the Label editing, move cursor
to "OK" and press Near or eNTer key to save
completed label. To abort current change, move
cursor to "Cancel" and press Near or eNTer key.
auTO PaN SeTuP

AUTO PAN SETUP

APAN NO.
1ST POS.
2ND POS.
APAN SPEED
CLEAR APAN
BACK
EXIT
• Auto Pan Number
Selects Auto Pan number to edit. If a selected Auto
Pan has not defined, "NOT USED" is displayed in 1st
Position and 2nd Position
• 1st Position / 2nd Position [PRESET 1~128]
Set up the 2 position for Auto Pan function. If a
selected preset is not defined, "UNDEFINED" will be
displayed as shown below.
AUTO PAN SETUP
APAN NO.
1ST POS.
2ND POS.
 – 36x IP Smart Dome Camera
Back Space Char.
Space Char.
1
NOT USED
NOT USED
30/SEC
CANCEL
[1~8]
1
PRESET5
PRESET8
UNDEFINED
When Auto Pan function runs, camera moves from
the preset assigned as the 1st point to the preset
assigned as the 2nd point in CW(Clockwise) direction.
Then camera moves from the preset assigned as the
2nd point to the preset assigned as the 1st point in
CCW(Counterclockwise) direction. In case that the
preset assigned as the 1st point is same as the preset
assigned as the 2nd point, camera turns on its axis by
360° in CW direction and then it turns on its axis by
360° in CCW direction.
• APAN(AUTO PAN) Speed [1°/sec ~180°/sec]
Sets Auto Pan speed from 1°/sec to 180°/sec.
• Clear APAN(AUTO PAN)
Deletes current Auto Pan data.
PaTTerN SeTuP

PATTERN SETUP

PATTERN NO.
CLEAR PATTERN CANCEL
<EDIT PATTERN>
BACK
EXIT
• Pattern Number [1~4 ]
Selects Pattern number to edit.
If a selected pattern number is not defined,
"UNDEFINED" will be displayed under selected
pattern number.
• Clear Pattern [CANCEL/OK]
Deletes data in current pattern
• Edit Pattern
Starts editing pattern.
[CANCEL/OK]
1
UNDEFINED