Software Update - Samsung SNC-C7478 Manual Del Usuario

Setup Tool
SOFTWare uPDaTe
Current Version
❖
• Shows the current firmware version.
How to upgrade
❖
• Click [Browse...] button and select the latest
version of the firmware. Its file name should be
Example) SNC-C7478_V01_090206.tgz.
• Click [Install] button. The file is uncompressed and
the software update begins. Software update may
take tens of minutes. To cancel an update, click the
[Cancel] button.
• When the software update is done, the system will
automatically restart. Since the current connection
is disconnected, you have to connect to the system
again.
M
Since, if the network is disconnected, the power fails or
the PC abnormally operates during a software update, the
system may not work afterwards. Care must be taken not
to cause a problem during an update.
reSeT
reset
❖
• Re-boots IP Smart Dome Camera.
Factory Default
❖
• Reset system configurations to the factory defaults
with following two options.
Except Network Parameter: Reset except values
on Network Parameters
(IP Address, Gateway, Subnet Mask, DNS Server
and Ports)
All: Reset all system configurations
M
After reset and restart, you have to connect to the system
again.
It takes a few minutes until the system booting is
completed. You cannot connect to the system until the
system booting is complete.
 – 36x IP Smart Dome Camera
After running <Factory Default> ➝ <All>, you have to
run <IP Installer.exe> program and setup network
settings such as IP address, Subnet mask, Gateway, etc.,
to connect to the Internet.
HTTPS
Connection Policy
❖
• Connection policy can be selected from <HTTP>,
<HTTPS with Self-Certificate>, <HTTPS with
Certificate from Authority (CA)>.
To use HTTPS with Certificate from Authority for
connection policy, you need to install a signed
certificate issued from certificate authority in
advance.
Install Certificate
❖
• To install the certificate to camera, you need type
Certificate Name (it can be arbitrarily assigned by
user), Certificate file issued from authority and a key
file. After completion, press [Install] button.
If certificate is installed successfully, the
summarized status of Installed Certificate will
be displayed. Also, the option button written as
'HTTPS with Certificate from Certificate Authority' in
the above becomes activated to be selected.
M
To connect the camera using HTTPS mode, you have to
type IP address of camera as "https://<Camera_IP>".