Samsung SNC-C7478 Manual Del Usuario página 42

Setup Tool
camera using the web browser. The default port
number is 80(TCP).
Device Port (TCP)
❖
• A port used to control video transmission. The
default value is 60001(TCP).
TCP Streaming Port
❖
• A port used to transfer video using the TCP
protocols. The default value is 60002(TCP).
uDP Streaming Port
❖
• A port used to transfer video using the UDP
protocols. The default value is 60003(UDP).
upload Port(TCP)
❖
• A port used to upgrade software. Default value is
60004(TCP).
IPv6 enable
❖
• IPv4 and IPv6 may be enabled simultaneously.
When IPv6 is enabled, your camera will receive an
IP address according to the configuration in the
network router.
Multicast address
❖
• Shows IP address set for video transmission using
UDP Multicast.
The default value is 225.128.1.128. It is
recommended to set it to between 224.0.0.0 and
239.255.255.255.
Multicast Port
❖
• Shows UDP port set for video transmission using
UDP Multicast. The default value is 60005(UDP).
TTl
❖
• TTL stands for "Time To Live" that allows you to set
the number of routers so that the packet can pass
through. Each router decreases the TTL value one
by one when a packet passes it through. If the TTL
value reaches 0, the packet cannot pass through a
router. The default value is 63. It is recommended
to set it to between 0 and 255.
rTSP Port
❖
• Set up the RTSP port number to use. The default
value is 554.
rTP Port range
❖
• Set up the range of port number to use for RTP
Protocol.
The Start number of RTP Port has to be even
number and the last number must be greater than
the start number +4. I.e. the difference should be
at least 4.
 – 36x IP Smart Dome Camera
rTP Multicast address
❖
• Set up IP Address for RTP/UDP Multicast.
rTP Multicast Port
❖
• Set up Port number used in RTP/UDP Multicast.
It is noted that RTP Multicast Port must be a even
number.
rTP Multicast TTl
❖
• Set up TTL for RTP/UDP Multicast. TTL is a
number between 0 ~ 255.
uSer
login authentication
❖
• You can determine whether to require login
authentication for users.
If it is set to <Enable>, the users can connect to the
system through login authentication, while it is set
to <Disable>, the users can connect to the system
without login authentication. However, users
connected to the system without login have USER
permission.
When the setting is complete, click the [Apply]
button.
user login ID/Password list
❖
• Shows user ID, password and level (permissions)
in a list.
You can register up to 10 users.
The default administrator ID is root.
<Administrator> cannot be deleted or added and
you can change the password only.
M
For the ID and password, up to 9 alphanumeric and some
special characters are allowed.
You cannot register a duplicated user ID.
You cannot register root or guest user ID.
About User Level

Administrator The Administrator can use all
functions and change the ptz control,
setup or search.
Operator The Operator can use all function
except setup and search functions.
User The User can monitor video only.