Humidity And Ultrasonic; Save Settings; Auto" Comfort Mode; Controlling Humidity - Boneco U350 Instrucciones De Uso

HUMIDIT Y AND ULTR ASONIC

SAVE SETTINGS

The BONECO U350 saves the last-used settings when it
is switched off. However, if the appliance is disconnected
from the power supply for a few seconds, it will start in
the operating mode.

"AUTO" COMFORT MODE

In mode the humidification is controlled automati-
cally and the humidity is set to 50%. As soon as the hu-
midity or the ultrasonic is manually adjusted, however,
the appliance leaves mode.
To return to mode, tap the symbol once.
The heater can be switched on or off without the appli-
ance leaving mode. mode also remains ac-
tive when setting the timer.

CONTROLLING HUMIDITY

The humidity can be set between 30% and 70%. In the
"Co" setting (for "Continuous"), the ultrasonic runs re-
gardless of the measured humidity. This means it does
not switch off until the tank is empty or the appliance is
switched off.
1. Tap the symbol. The current humidity indicator
starts flashing.
2. While the indicator is flashing, tap the
again until the desired humidity is set.
The value is applied after a few seconds. The indicator
stops flashing.

REGULATING PERFORMANCE

1. Tap the symbol multiple times until the desired
level appears on the display.
The symbol on the display indicates which of the three
levels (low/medium/high) has been selected:
symbol
29
en