Unpacking And Assembling; Unpacking; Assembly - Dirt Devil CENTRONIC M2615 Instrucciones De Utilización Y De Seguridad

2 Unpacking and assembling

2.1 Unpacking

2 Unpacking and assembling

2.2 Assembly

2
1
3
Fig. 2
1
3
2
Fig. 3
1
a
Fig. 4
1. Unpack the appliance and all its accessories.
2. Check the contents for completeness and possible
damages. Information regarding the scope of delivery
Page 64, "An overview of your Centronic".
ATTENTION:
Always transport/send the appliance in its original pack-
aging to avoid transport damages. Keep the packaging
for such an event. Dispose of no longer needed packag-
ing material according to the applicable regulations of
your country.
NOTE:
Immediately contact your dealer if you have found dam-
age resulting from transport.
WARNING:
Danger of injury! Only assemble the appliance when it is
not connected to the mains. Otherwise, the appliance
could be switched on by accident.
1. Push the end of the suction hose (Fig. 2/1) into the
socket opening (Fig. 2/2) of the cylinder vacuum clean-
er until you hear the lock click into place. Make sure that
4
the release button (Fig. 2/3) points down as illustrated.
2. Insert the handle (Fig. 3/1) into the upper end of the tel-
escopic tube (Fig. 3/2).
3. Attach the floor nozzle (Fig. 3/3) to the bottom end of
the telescopic tube (Fig. 3/4).
NOTE:
When attaching the floor nozzle, you might have to push
a bit harder.
4. Adjust the length of the telescopic tube. To do this,
press the telescopic tube lock (Fig. 4/1) down (Fig. 4/a).
Then extend the telescopic tube to the desired length
b
(Fig. 4/b). Let go of the release catch while pulling until
it locks in place. You will hear a distinct click.
GB
69