Installation And Switching On The Appliance; Before Switching On - Electrolux END44500X Manual Del Usuario

Installation and Switching On The Appliance

•
This appliance is connecting to 220-240V and 50 Hz.
•
Please call a qualified technician / authorized service to change any electrical part.
•
Before making the connection to the power supply, ensure that the voltage on the
nameplate corresponds to the voltage of electrical system in your home.
•
Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact, we suggest you call an electrician for assistance.
•
Manufacturer is not responsible for failure to complete the ground
connection as described in this booklet.
•
Do not place the appliance in direct sunlight.
•
Do not use in open air and shall not be exposed to the rain.
•
Place the refrigerator far from heat sources and in a well-
ventilated position. The refrigerator should be at least 50 cm from
radiators, gas or coal stoves and 5 cm far from electrical stoves.
•
Keep the top free for at least 15 cm.
•
Do not place heavy and lots of things on the
appliance.
•
If the appliance is installed next to another refrigerator or freezer, observe a
minimum distance of 2 cm to prevent condensation.
•
The appliance must be stand firmly and level on the floor Use the two front
levelling-feet to compensate for an even floor.
•
In order to have air circulation under the appliance, the space under the appliance
must be open. Don't close it with carpet , etc.
•
The outside of the appliance and the accessories inside should be cleaned with a
solution of water and liquid soap; the inside of the appliance with sodium bicarbonate
dissolved in lukewarm water. After drying replace all the accessories.
•
The appliance is not intended for use by people (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they
don't play with the appliance. If the supply cord is damaged it must be replaced by the
manufacturer or service agent or appointed person.

Before Switching On

•
Wait after 3 hours before plugging the appliance in to the main power to
ensure proper performance.
•
There can be an odour when you first switch on the appliance. It will disappear after the
appliance starts to cool.
41
UK