Faema E91 Diplomat Manual página 36

English
2.2 User dose - programming the coffee distribution keys
PROGRAMMING THE COFFEE DISTRIBUTION KEYS
(36, 37, 38 and 39 of groups 2, 3 and 4)
N.B.: Also valid for group 1 (group on the right as seen by the
operator) only if the CAPPUCCINO function is not activated.
When one of the coffee distribution keys is pressed (shown by the
flashing led), the following message will be displayed:
2.3 User dose - Programming the milk distribution key
PROGRAMMING THE MILK DISTRIBUTION KEY (42)
N.B.: Also valid if the CAPPUCCINO function is not activated.
When the milk distribution key is pressed (shown by the flashing led),
the following message will be displayed:
2.4 User dose - Programming the hot water distribution keys
PROGRAMMING THE HOT WATER DISTRIBUTION KEYS
(51.1, 51.2 and 51.3)
When one of the hot water distribution keys is pressed (shown by
the flashing led), the following message will be displayed:
To perform the programming of the coffee dose follow the procedure
herebelow:
1) Place a container by the hot water distribution nozzle (32).
3. Date and time setting - clock program
PRCLOCK PROGRAM
N.B. This is displayed only if the CLOCK function is activated.
The following message is displayed:
clock setup
monday
The day (e.g. Monday) flashes.
Press the “+” (72) and “-” (73) keys until the correct day is displayed.
Press the (71) key), the hours will flash (e.g. 07). Using the
4 4 4
“+” (72) and “-” (73) keys, change the numbers until the correct time
is displayed.
key 17
10.0
07:00
coffee dose
To perform the programming of the coffee dose follow the procedu-
re described in Paragraph 2.1.
To perform the milk dose programming, follow the procedure described
in Paragraph 21.
2) Keep the distributor key pressed, as evidenced by the flashing led
(the hot water dose counter starts from zero and increases in value).
3) When the quantity of water in the container has reached the
desired level, release the key (the counter will indicate the time that
corresponds to the set dose).
It is possible to vary the set dose via the “+” (72) and “-” (73) keys
(the time of the water distribution can also be increased or decreased).
How to perform other operations
The programming of another key is made by pressing one of the
other distribution keys.
When the (71) key is pressed, the message “user dose”
4 4 4
(Paragraph 2) will be displayed.
When the PROG (35) key is pressed, the message “clock program”
is displayed (See Paragraph 3).
N.B. If the “+” (72) and “-” (73) keys are kept depressed, the hours
number changes at a greater speed.
Press the (71) key, the minutes will flash (e.g. 00). Using the
4 4 4
“+” (72) and “-” (73) keys, change the numbers until the correct minutes
is displayed.
N.B. If the “+” (72) and “-” (73) keys are kept depressed, the
minutes number changes at a greater speed.
How to perform other operations
When the (71) key is pressed, the day will once again be
4 4 4
displayed (if this needs to be changed, follow the above procedures).
When the PROG (35) key is pressed, the message “duration
activate” is displayed (See Paragraph 4).
English
key 07
100
key 20
10.0