3M PELTOR TEP-200 EU Manual Del Usuario página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 72
EN
Attach/Detach Windscreen (not included with EEP-100 EU)
The windscreen may help minimize wind noise in high wind conditions.
Note: For the EEP-100 EU, windscreens may be purchased (see "Reorder").
1. Remove a disposable windscreen from the perforated windscreen sheet backing (Fig.
G:1).
2. Locate the earplug microphone (Fig. G:2).
3. Carefully center the disposable windscreen over the microphone port and press the
adhesive backed windscreen to the microphone port (Fig. G:3).
4. To detach, remove the windscreen and dispose when necessary. To attach, follow steps
1-3.
Note: After storing and/or recharging the earplug in the charging case, it may be
necessary to remove the old disposable windscreen and replace it with a new screen.
Fig. G
G:1
Storage of the TEP-200 EU/LEP-200 EU/LEP-200 EU OR Charger Case
Remove the batteries when storing the charging case for extended periods of time. Please
refer to the storage temperature ranges listed in the "Product Note" section.
Cleaning and Maintenance
Charging Case
The interior of the charging case should be kept free from dust and debris. The charging
points must make direct contact with the charging contact on the earpiece to ensure
charging. Cleaning these contact points with a cotton swab or soft cloth is recommended
if visual inspection reveals debris or if the user experiences problems charging the
earpieces.
To maintain water resistance capability, the perimeter of the charging case and seal ring
must be kept free of dirt and other materials that would prevent proper closing of the case
and the Micro B USB charging port cover must be closed.
TEP-200 EU/LEP-200 EU/LEP-200 EU OR/EEP-100 EU/EEP-100 EU OR Earpieces
Earpieces can be cleaned with a lightly damp cloth. Using a cotton swab to clean the
charging contacts may be required if debris is visible or if the user experiences problems
charging the earpieces.
Eartip Cleaning and Replacement
Remove and clean the eartips routinely and more frequently for those who produce
excess ear wax.
3M™ UltraFit™ Eartips (reusable)
Wash eartips with warm water and soap as needed. Look for tears or cracks under any of
the flanges. Replace as needed.
G:2
9
G:3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Peltor lep-200 euPeltor lep-200 eu orPeltor eep-100 euPeltor eep-100 eu or

Tabla de contenido