Additional Information - Pioneer GM-6500F Manual Del Propietário

Ocultar thumbs Ver también para GM-6500F:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40

Additional information

Specifications
Power source ............................. 14.4 V DC (10.8 V to 15.1 V
Grounding system ................... Negative type
Current consumption ............ 32 A (at continuous power,
Average current drawn ......... 9 A (4 W for four channels)
Fuse ................................................ 25 A × 2
Dimensions (W × H × D) ... 289 mm × 62 mm × 349
Weight .......................................... 3.3 kg (Leads for wiring not
Maximum power output ....... 760 W (190 W × 4)
Continuous power output ... 60 W × 4 (at 14.4 V, 4 W,
Load impedance ...................... 4 W (2 W to 8 W allowable)
Frequency response ............... 10 Hz to 70 kHz (+0 dB, –
Signal-to-noise ratio ............... 98 dB (IEC-A network)
Distortion ..................................... 0.05 % (10 W, 1 kHz)
Low pass filter:
(A ch)
Cut off frequency ........... 80 Hz
Cut off slope ..................... –12 dB/oct
(B ch)
Cut off frequency ........... 40 Hz to 500 Hz
Cut off slope ..................... –12 dB/oct
High pass filter:
(A ch)
Cut off frequency ........... 80 Hz
Cut off slope ..................... –12 dB/oct
(B ch)
Cut off frequency ........... 40 Hz to 500 Hz
Cut off slope ..................... –12 dB/oct
Gain control:
RCA ...................................... 200 mV to 6.5 V
Speaker .............................. 0.8 V to 26 V
Maximum input level / impedance:
RCA ...................................... 6.5 V / 22 kW
Speaker .............................. 26 V / 22 kW
Notes
! Specifications and the design are subject to
modifications without notice.
! The average current drawn is nearly the maxi-
mum current drawn by this unit when an
allowable)
4 W)
15 A (4 W for two channels)
mm
included)
20 Hz to 20 kHz ≦ 1 % THD
+N)
180 W × 2 (at 14.4 V, 4 W
BRIDGE 1 kHz, ≦ 1 % THD
+N)
85 W × 4 (at 14.4 V, 2 W,
1 kHz, ≦ 1 % THD+N)
3 dB)
audio signal is input. Use this value when
working out total current drawn by multiple
power amplifiers.
Appendix
13
En

Publicidad

Tabla de contenido
loading

Tabla de contenido