Din En 1953 - WALTHER PILOT WA 100 Instrucciones De Funcionamiento

Contents
Exploded Drawing
Declaration of CE-Conformity
List of replacement parts
1 General
1.1 Identification of Model Versions
1.2 Normal Use
1.3 Improper Use
2 Technical Description
3 Safety Instructions
3.1 Identification of safety instructions
3.2 General Safety Instructions
4 Assembly
4.1 Mounting of the Spray Gun
4.2 Connection of Input Lines
5 Starting / Handling
6 Retooling / Repairs
7 Cleaning and Maintenance
8 Troubleshooting and Corrective Action
9 Disposal of Cleaning and Servicing Substances
10 Technical Data
2
19
20
22
22
22
23
23
23
23
23
24
24
24
25
26
27
28
29
29
18
Declaration of CE-Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility that
the product(s) described below conform to the essential safety requirements. This declaration will
be rendered invalid if any changes are made to the equipment without prior consultation with us.
Manufacturer WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type Designation Automatic spray gun PILOT WA 100
PILOT WA 100
PILOT WA 100
PILOT WA 100
PILOT WA 100
PILOT WA 100
Intended purpose Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006 / 42 / EC
94 / 9 EC (ATEX Directives)
DIN EN ISO 12100-1
DIN EN ISO 12100-2
DIN EN 1127-1
Specification according 94 / 9 / EC
Category 2 Part marking
Authorized with the compilation of the technical file:
Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30
D- 42327 Wuppertal
Special remarks :
The named product is intended for installation in other equipment. Commissioning is prohibited
until such time as the end product has been proved to conform to the provision of the Directives
2006 / 42 / EC.
Wuppertal, the 1st of January 2010
i.V.
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety instructions
provided in the product documentation must be observed at all times.
V 20 310 (standard version)
V 20 311 (flushable)
V 20 312 (circulation version)
V 20 314 (circulation flushable version)
V 20 316 (Water - version)

DIN EN 1953

DIN EN 13463-1
Tech.File,Ref.:
II 2 G c T 5
2406
19