Instructions For Using The Motorcycle - Husqvarna WRE 125 2011 Manual Del Usuario

INSTRUCTIONS FOR USING THE MOTORCY-
CLE
NOTE*: If you are not familiar with the
motorcycle operation, read paragraphs
on "CONTROLS" before riding this mo-
torcycle.
PRE-RIDE CHECKS
Any time you ride your motorcycle, make a general in-
spection first and proceed to check the following:
- check fuel level and engine oil level;
- check transmission/gearbox oil level;
- check brake fluid level;
- check the steering by turning the handlebar both ways,
fully home;
- check the tyre pressure;
- check the chain tension;
- check the throttle twistgrip and adjust it, if necessary;
- turn the ignition switch to ON position;
- operate the turning indicators and check that the warn-
ing light comes on;
- check if the rear stop light is functioning;
- check that the display lights up and the lights turn on.
EN - 16
INSTRUCTIONS FOR RUNNING-IN
The exclusivity of the design, coupled to the high quality
of the materials used and the accuracy of the assembly,
guarantee the higher comfort right from the start. How-
ever, when running for the first 1500 Km (372.82 mi.),
SCRUPULOUSLY follow the rules mentioned herebelow.
Please note that FAILURE TO COMPLY WITH THESE RULES
MAY COMPROMISE THE LIFE AND THE PERFORMANCE OF
THE MOTORCYCLE:
- warm up the engine by running at low revs before us-
ing the motorcycle;
- avoid quick starts and never rev up the engine when in
low gear;
- ride at low speed until the engine is warmed up;
- apply both brakes several times to settle the pads and
the discs;
- do not maintain the same speed for a long time;
- do not ride for a long time without stopping;
- NEVER drive downhill with GEARBOX IN NEUTRAL, but
shift into gear to brake with the engine if necessary,
thus preventing the fast wear of the brake pads:
- Avoid high engine speeds for the first 500 Km (310
mi.
CHECKS WHILE RUNNING IN
When running in, the following should be checked out:
- WHEELS SPOKES TENSION;
- TIGHTENING OF WHEELS;
- FORK PIN TIGHTENING;
- CHAIN ADJUSTMENT;
- STEERING BEARING PLAY;
- HANDLEBAR TIGHTENING;
- ENGINE GRIP TO FRAME;
- SUCTION FITTING GRIP;
- HEAD AND CYLINDER NUTS GRIP.
Note*:
After break in, install a new spark plug
and change the transmission oil.
After running-in, check that vehicle nuts
and bolts are properly tightened.