Fault Finding Chart; Error Codes - BH FITNESS G-6488 Manual De Instrucciones

FAULT FINDING CHART

PROBLEM
1.The monitor does not
switch on.
2.The monitor switches on
but the motor fails to
start.
3.Walking motion is jerky
on the treadmill.
4.The machine stops (the
breaker trips).
5.Electrical shocks through
the handrail.
6.The treadmill belt skews
off centre.

ERROR CODES

Monitor screen displays E1
Monitor screen displays E2
Monitor screen displays E4
Monitor screen displays E6-E7
Do not hesitate to get in touch with us if you have any queries, by calling:
CHECKS
1) Make sure that the
machine is plugged in,
the ON/OFF switch in
position 1 and that the
safety key is inserted.
2) Check that the current
limiter is pressed in.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on
the sliding belt.
3.c) Check the tension on
the drive belt.
4) Check that the band is
lubricated.
5) Check that the machine
is plugged into an
earthed mains socket.
6.a) Check that the
machine is level on the
floor.
6.b) Check that the
machine does not wobble.
- Possible motor overload.
- Lubricate the belt.
- Switch the machine off and on again.
- Body fat function fault.
- Restart the machine and place your hands
correctly for a pulse rate reading.
- Elevation fault.
902 170 258
11
SOLUTIONS
1) Plug the machine into
the mains supply. Set
the switch to position 1
and insert the safety
key.
2) Switch the machine off
and press the circuit
breaker in. Lubricate the
treadmill band.
3.a) Lubricate the sliding
belt.
3.b) Adjust the belt
tension.
3.c) Adjust the drive belt
tension.
4) Reset the overload
button with the On /Off
switch at „0" and
lubricate the treadmill
band.
5) Plug the machine into
an earthed mains
socket.