1
5
6
7
8
-26-
Distributed by Volkswagen Zubehör GmbH Printed in Germany by Volkswagen Zubehör GmbH
1
1
1
Figure 5
1. Remove foam piece -1-.
Note
The foam piece -1- (for model with no towing hitch) is to be
replaced by a foam piece for model with towing hitch. The foam
piece for a model with a towing hitch is not part of the items
supplied and must be ordered separately,
part number: 2K7 087 252.
Figure 6
1. Remove bolts/screws (arrows) from both sides and remove
impact damper -1-.
2. Position towing hitch in installation position and tighten
bolts/screws (arrows), from items supplied (item 3) on both
sides hand-tight.
Figure 7
1. From inside, tighten towing hitch securing bolt/screw -1- on
longitudinal member on left side of vehicle.
Specifi ed tightening torque: 70 Nm + 90°
Figure 8
1. From outside, tighten towing hitch securing bolt/screw -1-
on longitudinal member on right side of vehicle.
Specifi ed tightening torque: 70 Nm + 90°
2. Tighten bolts/screws (arrows, fi g. 6) on both sides.
Anzugsdrehmoment: 50 Nm + 90°
3. Reinstall bumper cover.
Further installation is carried out in reverse order of removal.
GB
GB