Installation Of The Machine - John Bean T 3300-24 Manual Del Operario

2
2a
12

Installation of the machine

2. Installation of the machine
2.1 Installation
The tire changer can be installed on any concreted floor or
on any floor covered with a similarly hard floor covering.
It is recommended to secure the machine to the ground at
the four points provided with anchor bolts M10, or with
appropriate dowels. Apart from the property of the floor, the
Health and Safety at Work regulations as well as all other
national regulations on the working environment must be
taken into account when choosing site.
For installation on a higher floor check rated load of that
floor. In general we recommend to consult a construction
expert before any installation on a higher floor.
Machine dimensions are given in Fig. 1 of section "View of
the machine".
2.2 Fitting the machine post
WARNING:
THE WORK DESCRIBED BELOW MUST BE DONE
BY A TECHNICIAN AUTHORISED BY THE DEALER.
To optimise the packaging or to guarantee greater safety
during transportation, the machine may be delivered with
some parts disassembled.
Upon receiving the machine, some important parts may
need to be reassembled. Although these are simple
operations, we recommend that you follow the instructions
provided below.
Mounting the vertical column (Fig. 2):
A.
Remove the column base guard "1" and the two lateral
holders (if present) from the machine. Cut and remove
the straps holding the shaped washers "2" in position.
B.
Lift the column "0" with an appropriate lifting tool (crane,
fork lift) and a belt of sufficient capacity (200 kg). A second
person is required to help with this operation. BE CAREFUL
NOT TO DAMAGE THE AIR HOSES "3". Insert the air hose
through the hole "H" in the cabinet.
C.
WARNING: Before inserting the column fixing pin "4",
grease and position the shaped washers "2", as
illustrated. Insert the column in its seat, then fit the pin "4",
the two tapered bushings "5", the washers "6" and the
nuts "7". Tighten the nuts evenly on both sides and
manually finish tightening until the tapered bushings are
locked in the seats.
IMPORTANT!
THEN TIGHTEN THE NUTS "7" WITH A TIGHTENING
TORQUE OF 90 N/m.
D.
Tilt the column backwards. Pull the rod "8" of the tilting
cylinder and connect it to the column with the pin "9". Lock
pin with the split pin "10".
E.
Remove the left side of the machine and attach air hose
"3" (tool movement) to the pedal assembly connector "11".
Operation manual T 3300-24