Tabla de contenido
Publicidad
26a
40
Beading the tires
If the machine is fitted with the beading system for
Tubeless tyres integrated in the slidings of the
turntable, follow the procedure set out below.
Beading with Tubeless device on turntable:
Proced as follows:
A. If possible lock the wheel from inside. Outside
locking reduces efficiency of the bead seater.
B. Connect the inflation hose to the valve stem.
C. Lift the tire with both hands so that upper bead is
sealed to the rim edge (Fig. 26a).
D. Press the inflation pedal down swiftly. The top bead
is already sealed by the lifting motion. The air from
the bead seater jets will rebound into the bottom
sidewall driving it into place and creating a seal.
E. Complete inflation as described at the beginning of
this section.
WHEN OPERATING THE BEAD SEATER AND
INFLATOR IT IS MANDATORY TO WEAR EAR
PROTECTORS AND SAFETY GLASSES TO
PREVENT CONTAMINATION FROM NOISE, DUST
AND CHIPS BLOWN BY THE AIR JETS.
Operation manual
T 3300-24
Publicidad
Tabla de contenido
