Loose Parts; Mounting The Battery Charger (Optional) - Toro Power Plex 51130 Manual Del Usuario

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Note:
The battery pack is not fully charged when you purchase it. Before using the tool for the first time, refer
to Charging the Battery Pack (page
1
Mounting the Battery
Charger (Optional)
No Parts Required
Procedure
If desired, mount the battery charger securely on a
wall using the wall-mount key holes on the back of
the charger.
Mount it indoors (such as a garage or other dry place),
near a power outlet, and out of the reach of children.
Refer to Figure 1 for assistance in mounting the
charger.
Note:
Slide and twist the charger over the
appropriately positioned hardware to secure the
charger in place (hardware not included).
Description
No parts required
No parts required
Auxiliary handle
Guard
Phillips head screw
Wire edge guard
12).
Qty.
–
Mount the battery charger (optional).
–
Unfold the handle.
1 Install the auxiliary handle.
1
Mounting the guard to the base of the
trimmer.
3
1 Installing the edge guard
7
Use
Figure 1
g194202