Function Test Of The Speed Signal, Reverse Signal, Internal Sensors; Function Test Of The Gps Aerial - Pioneer ANH-P10MP Manual De Instrucciones

Setting the Navigation
Function test of the speed signal,
reverse signal, internal sensors
1 In service garage mode, select
with the rotary stick and press to confirm.
2 Move the vehicle several metres forwards
or backwards for the speed signal function
test.
The number after
at a low speed).
The number after
idling or accelerating when the vehicle is
parked.
3 Engage the reverse gear for the reverse
signal function test.
The number after
to ( to ).
1 1 0
4 In order to quit the sensor test, press the
button.
NAVI/OK
The unit switches back to service garage mode.
25
En
SENSORS
: should increase (even
WHEEL
: should not increase if
WHEEL
: should jump from
REVERSE

Function test of the GPS aerial

1 In service garage mode, select
with the rotary stick and press to confirm.
If GPS reception is functioning properly, the
number of satellites received (e.g.
date and time (e.g.
of locationing currently possible
are displayed.
The values after
At least
FIX 2D
cessful calibration. A certain amount of time
may be required to reach this value (do not
move the vehicle during this period).
2 In order to quit the GPS test, press the
button.
NAVI/OK
The unit switches back to service garage mode.
0
SAT 3/8
) and the type
07.04.19 14:56:04
FIX
: and : should not change.
X Y
is required for quick and suc-
GPS INFO
), the
(e.g. )
3D